Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 265)

265
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en TQM
Logfile, continued
Record
For each measurement a record is
stored containing:
• Points defining the plane in local or
instrument coordinates, depending
on settings.
• Plane parameters (standard
deviation, no. of points used,
offset)
• Coordinates of points measured
on plane.
TPS1100 Prog. Reference Plane V 2.00
Instrument
: TCRA1102plus, Serial 618268
Meas.File : MYFILE01.GSI
Progam Start : 12/11/2000 at 15:15
Define Local Plane
Point Id X-Coord (m) Y-Coord (m) Z-Coord (m) Dd (m) Status
Station coord 2 1.936 -3.142 1.936
100 -0.000 0.001 -0.000 0.001 ON
101 3.458 -0.002 3.458 -0.002 ON
102 3.310 0.002 3.310 0.002 ON
103 2.222 -0.263 2.222 -0.263 OFF
104 0.644 -0.001 0.644 -0.001 ON
No. of Pts : 4
s0 (m) : 0.000
Offset (m) : 0.000
Offset Pt. : -----
Points Measured
Point Id X-Coord (m) Y-Coord (m) Z-Coord (m) Dd (m)
201 0.727 0.000 0.404 -----
202 1.835 -0.004 1.095 -0.004
203 -0.028 -0.065 2.089 -0.065
204 2.175 -0.290 0.170 -0.290
205 2.519 0.000 0.908 -----
Typical logfile entries in the "Reference Plane" program.