Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 140)

140
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Local Resection
Hz. Ori
Angular correction needed to orient
the instrument
Set orientation and station
coordinates on the
instrument. Note that this key will end
the program.
Record the following results
in the measurement job:
WI 11 Station Point Number
WI 25 Orientation correction
WI 84 Station Easting
WI 85 Station Northing
WI 86 Station Elevation
WI 87 Last reflector height used
WI 88 Instrument Height
Exit the program.
Configuration
Depending on the
configuration that is loaded
onto your TPS1100 instrument, you
may not see some or all of the
options referred to below. See your
Leica Geosystems dealer for more
information about the configuration of
your instrument.
Configuration Editor
Start the "Configuration
Editor" from the
"STATION DATA" dialog.
The "Configuration Editor" sets
parameters for further program
operations:
Two Faces
YES for dual-face measurement,
NO
for single-face.
Meas. Job
Selection of the measurement job for
recording measurements.
Calculation, continued
LRes\ Configuration
Two Faces : NO
Meas Job : FILE01.GSI
DATA Job : ALNFILE0.GSI
CONT DEFLT INFO
MC
QUIT