Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 266)

266
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Monitoring
DTMSO\ Select DTM File
Dir. : D:\DTM
DTM File : FILE01.DXF
DXF Layer : TRIANGLE
CONT DFLT INFO
MC
Introduction
This manual describes the "DTM-
Stakeout" program for the TPS1100
Professional series instruments. The
program is used to compare
measured elevations to a stored
Digital Terrain Model. After
measurement the CUT or FILL value
between existing ground and the
DTM is displayed.
"DTM Stakeout" can be used to stake
out points where the DTM represents
the surface to be staked.
It can also be used to compare
existing ground to the DTM, e.g. for
quality control purposes where the
DTM represents the final project
surface.
"DTM Stakeout" requires the
instrument station to be setup and
oriented. The instrument must also
be configured in the same units as
those used in the DTM.
DTM-Stakeout
1
100pr81
Dir.
Select the directory where the DTM
file is stored.
Select DTM File
The first dialog allows selection of the
DTM file to be used. The file can be
in AutoCad DXF format or in Leica
GSI format (see chapter
Data
Formats).
,
,,
,,
,















E
H
N
DHtcut
Refl.Ht