Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 54)

54
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Free Station
Introduction
Free Station
This program can be used to deduce
the three-dimensional coordinates for
the instrument station and the
horizontal orientation of the from
measurements to a maximum of 10
target points.
For simultaneous determination of
the station elevation, height of
instrument and height of reflector
must already have been input and
the elevation of the target points
must be known.
You may use target points with
elevation only.
The program allows measurement in
single or dual-face mode.
Directions to target points can be
determined, as can any combination
of direction and distance. To compute
the position coordinates, at least
three elements (2 directions and 1
distance) are necessary.
Station Data
Enter station point number and height
of the instrument.
Proceed to define the target
points.
Start the
"CONFIGURATION"
Frest\ Station Data
Station Id: 1
Inst. Ht. : 1.555 m
MC
CONT
1
100pr17
Station
3rd target
2nd target
1st target
Dist 1
Dist 2
Dist 3
Orientation
Hz1
Hz2
Hz3
Hz = 0
This manual describes the "FREE
STATION" program of the TPS1100
Professional series.