Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 61)

61
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Free Station
Configuration
Depending on the
configuration that is loaded
onto your TPS1100 instrument, you
may not see some or all of the
options referred to below. See your
Leica Geosystems dealer for more
information about the configuration of
your instrument.
Start the "Configuration Editor" from
the "STATION DATA" dialog.
Configuration Editor
Ht Acc TP
Height accuracy of the target points.
The entered value, is used as an "a
priori" accuracy in the calculation.
The height is regarded as "error
free", if the computed standard
deviation is within twice the entered
value.
Posn Acc TP
Position accuracy of the target points.
The entered value, is used as an "a
priori" accuracy in the calculation.
The position is regarded as "error
free", if the computed standard
deviation is within twice the entered
value.
Two Faces
YES for dual-face measurement,
NO
for single-face.
The "Configuration Editor" sets
parameters for further program
operations:
Hz Ori Acc
Limit for the standard deviation of the
orientation. The orientation is
regarded as "error free", if the
computed standard deviation of the
orientation is within twice the entered
value.
FreSt\ Configuration
Hz Ori.Acc: 0°00'32''
Ht Acc TP : 0.025 m
Pos Acc TP: 0.025 m
Two Faces : NO
User Disp.: NO
Log File : OFF
MC
QUIT
Log FlName: FREE_STA.LOG
Meas Job : MYFILE.GSI
Data Job : DEFAULT.GSI
CONT DEFLT INFO