Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 98)

98
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Sets of Angles
Sets Menu
Sets menu
The target Point Ids and the
sequence of measurement to the
target points are stored in the
program during the observation of
the first half of the first set (in Face I.)
This is the "Learning Phase." To
complete the first set, and during the
observation of the additional sets,
you will be offered the target points in
the sequence defined during the
learning phase. If you are using a
non-motorized instrument, the
horizontal and vertical differences will
be displayed, to guide you to the
correct target point. Motorized
instruments will automatically drive to
the target point. TCA- and TCRA-
instruments may make all
measurements automatically, after
the learning phase.
Start the
“CONFIGURATION“
Option, if available.
Measure Mode
• Measure First Set
This is the learning phase of the Sets
of Angles program. Your inputs and
measurements will be stored by the
program to guide you through the
balance of the measurement
process.
You must measure to all desired
target points in this set during the
learning phase, and you may not add
target points to the set after you
leave the learning phase.
SETS\ Sets Menu
1 Measure First Set
2 Measure Further Sets
3 Calculate Horizontal Sets
4 Calculate Vertical Sets
5 Calculate Distance Sets
6 End Program
CONT
MC
CONF QUIT
SETS\ First Set
Set No. : 1
Seq. No. : 1
Face : I
Point Id : 501
Refl. Ht. : 1.300 m
Auto Meas.: YES
MEAS LIST <-- --> DONE
MC
QUIT
Prism Type:Leica 360°prism
PrismConst:
0.0 mm