Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 87)

87
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Hidden Point
Example of Measurement data
Measurements to Point Ids 2 and 3
(the first two records) are the raw
measurements. The measurement to
Point Id 4 is the hidden point
measurement - the measurement
that could have been made if Point Id
4 was not behind an obstruction
between it and the instrument station
(with a Refl. Ht = 0.)
In this GSI8 example, the Recording
Mask is the standard polar mask
(Point Id, Horizontal Circle, Vertical
Circle, Slope Distance and ppm /
Offset. The actual data recorded will
be determined by the Recording
Mask in effect at the time the
measurement and/or hidden point
data are recorded.
110041+00000002 21.322+07018850 22.322+06455150 31..00+00003078
5 1 . . 1 . + 0 0 0 0 + 0 3 4
110042+00000003 21.322+10896450 22.322+06213050 31..00+00002910
Accept the current
configuration and proceed to
"MEASURE ROD"
Note that all parameters for the rod
you are using must be defined before
you can proceed. If any of the
parameters have not been defined,
the program will issue an error
message to this effect. Press OK to
clear the message, then make any
necessary settings in the
"CONFIGURATION".
Set values to default. Default
values are displayed.
Displays date and version of
the running application.
Configuration, continued
Example: GSI8 Measurement data
Logfile
Hidden Point does not generate a
logfile.