Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 149)

149
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en COGO
Azimuth
Display of corrected Azimuth
Accept displayed values and
proceed to
dialog "Distance
to Traverse" .
Azimuth
Display of entered Azimuth
Multiply
Entering multiplication factor
Divide
Entering division factor
Add
Entering angle for a correction to the
right
Subtract
Entering angle for a correction to the
left
Defining horizontal distance
Horiz.Dist
Entering horizontal distance
Offset
Entering parallel displacement.
Only active if "YES" is entered in the
configuration during "Offset:"
Left = negative parallel offset
Right = positive parallel offset
Accept displayed values and
proceed to
dialog "Traverse
results".
Defining direction by Azimuth, continued
COGO\ Modify Azimuth
Azimuth : 0°00’00’’
Multiply : -----
Divide : -----
Add : 0°00’00’’
Subtract : 0°00’00’’
Azimuth : 0°00’00’’
CONT
MC
QUIT
COGO\ Traverse
Distance to Traverse
Horiz.Dist: 0.000 m
Offset : 0.000 m
CONT INV RCALL
MC
MODIF QUIT