Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 247)

247
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Auto Record
As long as the prism is moving
continuously but never gets more
than 5 meters from XY = 10, no
more data will be recorded. If you
stop and center the prism over a
point of interest, say at X = 12, Y =
12, for 2 seconds, that
measurement data will be
automatically recorded and will
reset the distance interval as well.
Then, as long as the prism is
moving continuously but never
gets more than 5 meters from XY
= 12, no more measurement data
will be automatically recorded. - If you move directly North from XY
= 12, more measurement data will
be automatically recorded as you
move past X = 12, Y = 17. The
exact measurement data to be
recorded will depend upon how
rapidly you are moving and how
close to the 5 meter limit the
preceding measured position was.
- If you continue moving directly
North from X = 12, Y = 17 and
press REC to trigger a manual
position recording as you pass X =
12, Y = 20, that will reset the
distance interval as well. Then, as
long as the prism is moving
continuously but never gets more
than 5 meters from X = 12, Y = 20,
no more measurement data will be
automatically recorded.
This combination of Distance Interval
and Stable Position modes is ideal
for automating a topographic survey
of an irregularly detailed site. In
relatively open areas, measurement
data will be automatically recorded as
the prism is "scanned" across the
surface, based on the specified
distance interval. In areas with more
detail, measurement data will be
automatically recorded whenever the
prism is centered over a point of
interest for the indicated amount of
time.
Notes on Configuration, continued