Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 143)

143
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en COGO
Configuration
Start the "Configurations Editor" from
the "COGO MENU" dialog.
The "Configuration Editor" sets
parameters for further program
operations:
Direc. Type Bearing
Azimuth
Offset
YES entering a parallel
displacement is possible
NO entering a parallel
displacement is not possible
Meas Job
Selection of the measurement job for
recording measurements.
Data Job
Selection of the data job containing
the fix point coordinates (control
data).
Depending on the
configuration that is loaded
onto your TPS1100 instrument, you
may not see some or all of the
options referred to below. See your
Leica Geosystems dealer for more
information about the configuration of
your instrument.
Accept displayed values and
proceed to the dialog "COGO
MENU".
Set all values to default. The
values are shown in the
dialog above.
Displays date and version.
Exit the program.
COGO\ Configuration
Direc.Type: AZIMUTH
Offset : YES
Meas Job : FILE01.GSI
Data Job : FILE02.GSI
CONT DEFLT INFO
MC
QUIT