Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 245)

245
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Auto Record
Three automatic recording modes
are available:
• Time Interval,
• Distance Interval
and
• Stable Position.
The intervals are applied relative to
the last recorded position, whether
triggered manually or automatically.
In all cases, the measurement data
will be recorded using the REC Mask
you have specified.
Configuration Options, continued
TimeInterv
When this mode is ON and the TCA-/
TCRA-instrument is following a prism
in the tracking measurement mode,
measurement data will be recorded
automatically whenever the time
since the last recorded measurement
data exceeds the time interval shown
here, i.e. every 5 seconds.
DistInterv
When this mode is ON and the TCA-/
TCRA-instrument is following a prism
in the tracking measurement mode,
measurement data will be recorded
automatically whenever the three
dimensional slope distance from the
last recorded measurement data
exceeds the distance shown here,
i.e. 5 meters.
Stable Pos,
StableTime
When this mode is ON and the TCA-/
TCRA-instrument is following a prism
in the tracking measurement mode,
measurement data will be recorded
automatically whenever the prism
remains within a circle of the radius
for the length of time shown here, i.e.
the position remains constant within 5
centimeters for 2 seconds.
AREC\ Configuration
TimeInterv: 5sec
DistInterv: 5.000 m
Stop Pos. : 0.050 m
Stop Time : 2sec
CONT TIME DIST ST&GO INFO
MC
QUIT