Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 251)

251
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Monitoring
Introduction
This manual describes the
"Monitoring" program for the
TPS1100 Professional series
instruments.
The program is used for repeated
automatic measurements. It
measures angles and distances to
predefined points.
The location of the points can be
"learned" by measuring to them in the
"Learning Points" dialog or point
information can be taken from a
*.GSI file stored on the PCMCIA
card.
Monitoring
MONI-01
Max. 50 points and as many
repetitions as desired, at any time
intervals.
The measurements can be:
• repeated as often as is necessary,
• at any time
• performed in both faces.
The point number, the horizontal and
vertical angles and the slope distance
for the individual measurements are
stored on the memory card.
Points to be measured must be
permanently equipped with Leica
Geosystems prisms.
The instrument must be firmly
mounted on a tripod or pillar.
Measurements are limited only by the
storage capacity of the PCMCIA
memory card.
With the timer function the program
can trigger automatic measurements
at any predefined interval.