Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 74)

74
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Reference Line
Method Dialog
Open "Method" dialog
from "L&O Results"
dialog.
REFL\ Select Method
Stake Mode:ORTHO - REFLINE
Auto Pos. :
2D
Symbols : Yes
CONT
MC
QUIT
Stake Mode
Select the stakeout mode.
ORTHOGONAL TO REFLINE
Differences between entered and
measured Offset values are
displayed after the first distance
measurement.
ORTHOGONAL TO STATION
Displays orthogonal values based on
the line defined by instrument station
and reflector position.
POLAR STAKEOUT
Displays differences between
calculated and measured direction
and horizontal distance after first
distance measurement.
Auto Pos.
Select positioning method.
(Motorized instruments only):
Off
Automatic positioning off.
2D Positioning of the horizontal
drive.
3D Positioning of the vertical and
horizontal drive.
Symbols
Arrows can be used to guide the rod
person to the point to be staked.
The available symbols depend on the
selected method.
• NO
Symbols are not used.
Ortho - RefLine
• YES
Symbols guide the rod person
along the reference.
Ortho - Station/Polar Stakeout
• TO STA. (
↓↑ ↓↑ ↓↑ ↓↑ ↓↑ )
Guidance at the rod, in relation to
the instrument station.
• FROM STA. ( ↑↓ ↑↓ ↑↓ ↑↓ ↑↓ )
Recommended to guide rod
person from instrument station.