Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 57)

57
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Free Station
Inst.Height
Instrument Height
East
Calculated Easting for the station
North
Calculated Northing for the station
Elevation
Calculated Elevation for the station
Hz. Ori
Oriented direction
σ σ σ σ σ
East
Standard deviation of Easting
σ σ σ σ σ
North
Standard deviation of Northing
σ σ σ σ σ
Elev
Standard deviation of the Elevation
σ σ σ σ σ
Hz. Ori
Standard deviation of the Orientation
Calc Scale
YES scale factor is calculated,
NO scale factor is not calculated
Note that this parameter is
displayed only if sufficient
measurement were taken.
Scale
The scale factor of the free station
calculation.
Note that the scale is not shown if
set to NO.
Set orientation and station
coordinates on the
instrument.
Record the following results
in the active measurement
job:
WI 11
Station Point Number
WI 25 Orientation correction
WI 84 Station Easting
WI 85 Station Northing
WI 86 Station Elevation
WI 87 Last reflector height used
WI 88 Instrument Height
Measure more points. The
program will recall the
"TARGET POINT" dialog.
Show the results of individual
measurements on the screen
(see dialog "More Information").
Compare the Free Station
results to the station
coordinates and orientation currently
set in the instrument.
Select between the
"Robust" method and
the Least Squares method.
Sketch of the station
and the reference
points used.
Exit the program.
Calculation, continued