Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 156)

156
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en COGO
INPUT Enter bearing,
mangnetic bearing resp.
azimuth (if "Azimuth" is selected in
the configuration for "Direc. Type:"
RCALL Call up of a direction which
has been previously stored using the
function "Polar calculation".
Changing the direction
(as dialog box "Modify
Bearing", resp. "Modify Azimuth")
Exit the program.
INPUT Entering radius
RCALL Call up of a radius
which has been previously stored
using the function "Polar
calculation".
Changing the direction
(as dialog box "Modify
Distance").
Exit the program.
The following dialog box shows the
result of the bearing-distance
intersection:
Bearing-Distance Intersection, continued
Enter distance from second point:
Horiz.Dist.
Entering radius
Accept displayed values.
Determining the radius by
means of the function "Polar
calculation" (refer to chapter
"Inverse").
COGO\ Bearing-Distance
Distance from 2nd point
OK : 0.000 m
CONT INV RCALL
MC
COGO\ Brg-Dist Results
Point Id : -----
East : 0.000 m
North : 0.000 m
Elevation : -----
CONT OTHER STORE STAKE
MC
QUIT