Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 106)

106
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Sets of Angles
• Calculate Horizontal and Vertical
Sets
The general display format is the
same for horizontal directions,
vertical directions and slope
distances. The data displayed refer
to the calculation function selected
from the Sets Menu.
Standard deviations of a single
direction in both faces (
σ
Singl.Dir)
and the standard deviation for an
averaged direction from all sets
(
σ
Avg. Dir) are calculated.
Computations of standard deviations
require that all targets and sets are
observed in two faces. Exceptions
may exist, in which case the standard
deviation should be seen as an
approximation to be used as a field
control. The correct standard
deviations a posteriori in this case
can be calculated using the recorded
data and a suitable computation
method.
Calculate Mode
Pts. Active
Number of observed points used in
the calculation.
Sets Active
Number of observed sets used in the
calculation.
σσσσσ
Singl.Dir
Standard deviation of one observed
horizontal or vertical direction, ok
slope distance
σσσσσ
Avg. Dir
Standard deviation of an average
direction ok slope distance from all
sets.
Results of sets of angles are
recorded in the Meas Job.
( For details see dialog "FORMATS
AND MORE INFORMATION")
Show the results of individual
measurements on the
screen. ( For details see dialog "More
Information").
Returns to Set Menu.
Exit the program.
SETS\ Hz Set Results
Pts Active: 4
Set Active: 2
σσσσσ Singl.Dir: 0°00’24’’
σσσσσ Avg. Dir: 0°00’17’’
CONT STORE MORE
MC
QUIT