Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 95)

95
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Area
Store the current
configuration and proceed to
the dialog "Measure Point".
Points can be added to the current
area or a new area can be started.
Set the values to default.
Display date and version of
the running application
Exit the program.
Dual-face Measurement
In the dual-face mode, the program
will prompt for measurements in both
faces. When both measurements are
taken, the program will check the
difference between the two. If the
difference in angle is within 27'
(0.5 gon) and the difference of two
measured distances is within 0.5 m
(1.64 ft), the observations will be
averaged. These tolerances are used
to avoid errors in target identification.
If exceeded an error message will be
displayed.
Configuration Editor, continued Log File
If "Log File" is set to ON the
measurements and the results are
stored in the ASCII-file specified
within the "Configuration Editor". This
file is created in the directory LOG on
the memory card. Subsequently, you
can read the memory card on your
PC and obtain a hard copy of the
Log-file.
Data will always be
appended to the specified
Log-file.
The Log-file contains the following
information:
Header
The header line will contain the
program used, information about the
instrument, the name of the data file
as well as date and time.