Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 91)

91
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Area
Measure a distance
without recording.
Enter the target data.
Import target coordinates.
Select arc defined by 2
points and radius.
Call up the CODE function.
Exit the program.
• Radius Arc
Determine the two points of an arc
sequentially. After the end point the
"Measure point" dialog prompts to
input the radius.
Enter the target data.
(see User Manual)
Import target coordinates.
Press 3 Pt. to switch to
the 3-Point Arc method.
Exit the program.
For arcs to the left enter
the radius positive and for
arcs to the right enter the radius
negative.
Simultaneously measure and
record data of the end point
of arc in the active measurement job.
Measure a distance
and record data of the
end point of arc in the active
measurement job.
Measure a distance
without recording.
Arcs, continued
AREA\ Radius ARC
Radius ARC, end point:
Point Id
: 1
Refl. Ht. : 0.000 m
Hz : 95°55’50’’
V : 91°16’20’’
Slope Dist: ----- m
ALL DIST REC CONT TARGT IMPOR
MC
RAD QUIT
Elev.Diff.: ----- m
East : ----- m
North : ----- m
Elevation : ----- m