PLANET WGS3-2820 - Manual (Page 111)

User’s Manual of WGS3-2820/WGS3-5220
111
Selection Criteria
。 unit/slot/port - Selects the interface to be configured.
Non-configurable data
。 MAC Address - Displays the MAC addresses learned on a specific port.
。 VLAN ID - Displays the VLAN ID corresponding to the MAC address.
。 Number of Dynamic MAC addresses learned - Displays the number of dynamically learned MAC addresses on a
specific port.
Configurable Data
。 Delete the MAC address and vlan id - Deletes a MAC address and the c orresonding vid from the list of denied MAC
addresses for the selected interface .
Command Buttons
。 Submit - Applies the new configuration and causes the changes to ta ke effect.These changes will not be retained
across a power cycle unless a save configuration is performed.
4.3.3.8 CPU Multicast Configuration
Figure 4-3-15 CPU Multicast Rate Configuration
Selection Criteria
。 unit/slot/port - Selects the interface to be configured.
Configurable Data
。 Admin Mode - Specifies whether Admin mode is enabled on the switch. Value is enabled or disabled.
。 CPU Multicast Rate - Sets the CPU Multicast Rate.