PLANET WGS3-2820 User Manual
Page 242
User’s Manual of WGS3-2820/WGS3-5220
242
(config)# router ospf
(config-router)# area 0.0.0.1 virtual-link 10.0.0.2
4.6.4.11 OSPF Virtual Link Summary
Figure 4-6-28
OSPF Virtual Link Summary
Non-Configurable Data
。
Area ID
- The ID of an OSPF area to which one of the router interfaces is connected. An Area ID is a 32 bit integer in
dotted decimal format that uniquely identifies the area to which an interface is connected.
。
Neighbor Router ID -
The input neighbor Router ID
。
Hello Interval -
The configured hello interval for the OSPF virtual interface.
。
Dead Interval -
The configured dead interval for the OSPF virtual interface.
。
Retransmit Interval -
The configured retransmit interval for the OSPF virtual interface.
。
Iftransit Delay Interval -
The configured transit delay for the OSPF virtual interface.
Command Buttons
Refresh
- Refresh the data on the screen with the present state of the data in the switch.
4.6.4.12 OSPF Route Redistribution Configuration
This screen can be used to configure the OSPF Route Redistribution parameters. The allowable values for each fields are
displayed next to the field. If any invalid values are entered, an alert message will be displayed with the list of all the valid
values.