PLANET WGS3-2820 - Manual (Page 456)

User’s Manual of WGS3-2820/WGS3-5220
456
12.7.11 area nssa translator-stab-intv (OSPF)
This command configures the translator <stabilityinterval> of the NSSA. The <stabilityinterval> is the period of time that an
elected translator continues to perform its duties after it determines that its translator status has been deposed by another
router.
▫ Format area <areaid> nssa translator-stab-intv <stabilityinterval>
▫ Mode Router OSPF Config
no area nssa translator-stab-intv (OSPF)
This command disables the nssa translator’s <stabilityinterval> from the specified area id.
▫ Format no area <areaid> nssa translator-stab-intv <stabilityinterval>
▫ Mode Router OSPF Config
12.7.12 area range (OSPF)
This command creates a specified area range for a specified NSSA. The <ipaddr> is a valid IP address. The <subnetmask> is a
valid subnet mask. The LSDB type must be specified by either summarylink or nssaexternallink, and the advertising of the
area range can be allowed or suppressed.
▫ Format area <areaid> range <ipaddr> <subnetmask> {summarylink | nssaexternallink} [advertise |
not-advertise]
▫ Mode Router OSPF Config
no area range
This command deletes a specified area range. The <ipaddr> is a valid IP address. The <subnetmask> is a valid subnet mask.
▫ Format no area <areaid> range <ipaddr> <subnetmask>
▫ Mode Router OSPF Config
12.7.13 area stub (OSPF)
This command creates a stub area for the specified area ID. A stub area is characterized by the fact that AS External LSAs are
not propagated into the area. Removing AS External LSAs and Summary LSAs can significantly reduce the link state database
of routers within the stub area.
▫ Format area <areaid> stub
▫ Mode Router OSPF Config
no area stub
This command deletes a stub area for the specified area ID.
▫ Format no area <areaid> stub
▫ Mode Router OSPF Config