PLANET WGS3-2820 - Manual (Page 447)

User’s Manual of WGS3-2820/WGS3-5220
447
▫ Format ip vrrp <vrid> ip <ipaddr> [secondary]
▫ Mode Interface Config
12.5.4.1 no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the interface. To delete the primary IP
address, you must delete the virtual router on the interface.
▫ Format no ip vrrp <vrid> <ipaddress> secondary
▫ Mode Interface Config
12.5.5 ip vrrp authentication
This command sets the authorization details value for the virtual router configured on a specified interface. The parameter {none
| simple} specifies the authorization type for virtual router configured on the specified interface. The parameter [key] is optional,
it is only required when authorization type is simple text password. The parameter <vrid> is the virtual router ID which has an
integer value ranges from 1 to 255.
▫ Default no authorization
▫ Format ip vrrp <vrid> authentication {none | simple <key>}
▫ Mode Interface Config
12.5.5.1 no ip vrrp authentication
This command sets the default authorization details value for the virtual router configured on a specified interface.
▫ Format no ip vrrp <vrid> authentication
▫ Mode Interface Config
12.5.6 ip vrrp preempt
This command sets the preemption mode value for the virtual router configured on a specified interface. The parameter <vrid>
is the virtual router ID, which is an integer from 1 to 255
▫ Default enabled
▫ Format ip vrrp <vrid> preempt
▫ Mode Interface Config
12.5.6.1 no ip vrrp preempt
This command sets the default preemption mode value for the virtual router configured on a specified interface.
▫ Format no ip vrrp <vrid> preempt
▫ Mode Interface Config