PLANET WGS3-2820 - Manual (Page 198)

User’s Manual of WGS3-2820/WGS3-5220
198
。 Restore Defaults for All Queues - Restores default settings for all queues on the selected interface.
。 Submit - Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
4.5.5.6 Interface Queue Status
Figure 4-5-31 CoS Interface Queue Status
Selection Criteria
。 Slot/Port - Specifies all CoS configurable interfaces. The option "Global" represents the most recent global
configuration settings. These may be overridden on a per-interface basis.
Non-Configurable Data
。 Queue ID - Specifies the queueID.
。 WRR weights / Minimum Bandwidth - Specifies the WRR weights or Minimum Bandwidth the valid range for WRR
weights is 1 to 15. minimum guaranteed bandwidth allotted to this queue when scheduling is WFQ.
。 Scheduler Type - Specifies thei type of scheduling used for this queue. the scheduling on a interface can be one the
following
ƒ
strict
ƒ
wfq
ƒ
wrr
ƒ
strict + wrr
ƒ
strict + wfq
。 Queue Management Type - Queue depth management technique used for queues on this interface. This is only
used if device supports independent settings per-queue.
Queue Management Type can only be one of the following:
ƒ
taildrop