PLANET WGS3-2820 User Manual

Page 316

Advertising
background image

User’s Manual of WGS3-2820/WGS3-5220

316

To view the network parameters the operator can access the device by the following three methods.

Simple Network Management Protocol - SNMP

▫ Telnet

▫ Web

Browser

"

Note

:

Helpful Hint: The user should do a “copy system:running-config nvram:startup-config” after configuring the

network parameters so that the configurations are not lost

Command

Details

show network

(in User EXEC)

Displays the Network Configurations

IP Address - IP Address of the interface

Default IP is 0.0.0.0

Subnet Mask - IP Subnet Mask for the interface

Default is 0.0.0.0

Default Gateway - The default Gateway for this interface

Default value is 0.0.0.0

Burned in MAC Address - The Burned in MAC Address used for

in-band connectivity

Locally Administered MAC Address - Can be configured to allow a locally

administered MAC address

MAC Address Type - Specifies which MAC address should be used for

in-band connectivity

Network Configurations Protocol Current - Indicates which network

protocol is being used

Default is none

Management VLAN Id - Specifies VLAN id

Web Mode - Indicates whether HTTP/Web is enabled.

Java Mode - Indicates whether java mode is enabled.

network parms

(in Privileged EXEC)

network parms <ipaddr> <netmask> [<gateway>]

IP Address range from 0.0.0.0 to 255.255.255.255

Subnet Mask range from 0.0.0.0 to 255.255.255.255

Gateway Address range from 0.0.0.0 to 255.255.255.255

Table 5-4

Quick Start up IP Address

Quick Start up Uploading from Switch to Out-of-Band PC (Only XMODEM)

Advertising
This manual is related to the following products: