PLANET WGS3-2820 - Manual (Page 410)

User’s Manual of WGS3-2820/WGS3-5220
410
▫ Mode Global Config
10.1.20 radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted when no response is received from the
RADIUS server. The retries value is an integer in the range of 1 to 15.
▫ Default 10
▫ Format radius server retransmit <retries>
▫ Mode Global Config
10.1.20.1 no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, when no response is received from the
RADIUS server, to the default value, i.e. 10.
▫ Format no radius server retransmit
▫ Mode Global Config
10.1.21 radius server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted to the RADIUS server if no
response is received. The timeout value is an integer in the range of 1 to 30.
▫ Default 6
▫ Format radius server timeout <seconds>
▫ Mode Global Config
10.1.21.1 no radius server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted to the RADIUS server if no
response is received, to the default value, i.e. 6.
▫ Format no radius server timeout
▫ Mode Global Config
10.1.22 show accounting
This command is used to display the configured RADIUS accounting mode, accounting server and the statistics for the
configured accounting server.
▫ Format show accounting [statistics <ipaddr>]
▫ Mode Privileged EXEC
If the optional token 'statistics <ipaddr>' is not included, then only the accounting mode and the RADIUS accounting server
details are displayed.
▫ Mode Enabled or disabled
▫ IP Address - The configured IP address of the RADIUS accounting server
▫ Port - The port in use by the RADIUS accounting server
▫ Secret Configured - Yes or No
If the optional token 'statistics <ipaddr>' is included, the statistics for the configured RADIUS accounting server are displayed.