53 shutdown, 54 shutdown all, 55 snmp trap link-status – PLANET WGS3-2820 User Manual
Page 366: 56 snmp trap link-status all
User’s Manual of WGS3-2820/WGS3-5220
366
8.6.53 shutdown
This command disables a port.
▫
Default Enabled
▫
Format shutdown
▫
Mode
Interface Config
8.6.53.1 no shutdown
This command enables a port.
▫
Format no
shutdown
▫
Mode
Interface Config
8.6.54 shutdown all
This command disables all ports.
▫
Default Enabled
▫
Format shutdown all
▫
Mode
Global Config
8.6.54.1 no shutdown all
This command enables all ports.
▫
Format no shutdown all
▫
Mode
Global Config
8.6.55 snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserverenable traps linkmode' command.
▫
Format
snmp trap link-status
▫
Mode
Interface Config
8.6.55.1 no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See 'snmpserver enable traps linkmode' command).
▫
Format
no snmp trap link-status
▫
Mode
Interface Config
8.6.56 snmp trap link-status all
This command enables link status traps for all interfaces.