PLANET WGS3-2820 User Manual

Page 80

Advertising
background image

User’s Manual of WGS3-2820/WGS3-5220

80

4.2.9.6 Upload File From Switch

Use this menu to upload a configuration or log file from the switch.

Configurable Data

。

File Type -

Specify the type of file you want to upload. The available options are Configuration, Error Log, System

Trace, and Trap Log. The factory default is Error Log.

。

TFTP Server IP Address -

Enter the IP address of the TFTP server. The factory default is 0.0.0.0

。

TFTP File Path -

Enter the path on the TFTP server where you want to put the file being uploaded. You may enter

up to 32 characters. The factory default is blank.

。

TFTP File Name -

Enter the name you want to give the file being uploaded. You may enter up to 32 characters.

The factory default is blank.

。

Start File Transfer -

To initiate the upload you need to check this box and then select the submit button.

Figure 4-2-46

Upload File from Switch

4.2.9.7 Ping

Use this screen to tell the switch to send a Ping request to a specified IP address. You can use this to check whether the switch

can communicate with a particular IP station. Once you click the Submit button, the switch will send three pings and the results

will be displayed below the configurable data. If a reply to the ping is not received, you will see No Reply Received from IP

xxx.xxx.xxx.xxx

, otherwise you will see Reply received from IP xxx.xxx.xxx.xxx : (send count = 3, receive count = n).

Configurable Data

。

IP Address -

Enter the IP address of the station you want the switch to ping. The initial value is blank. The IP

Address you enter is not retained across a power cycle.

Advertising
This manual is related to the following products: