PLANET WGS3-2820 - Manual (Page 344)

User’s Manual of WGS3-2820/WGS3-5220
344
8.5.25 snmp-server community rw
This command restricts access to switch information. The access mode is read/write (also called private).
▫ Format snmp-server community rw <name>
▫ Mode Global Config
8.5.26 snmp-server enable traps
This command enables the Authentication Flag.
▫ Default Enabled
▫ Format snmp-server enable traps
▫ Mode Global Config
8.5.26.1 no snmp-server enable traps
This command disables the Authentication Flag.
▫ Format no snmp-server enable traps
▫ ModeGlobal Config
8.5.27 snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps are sent only if the broadcast storm
recovery mode setting associated with the port is enabled.
▫ Default Enabled
▫ Format snmp-server enable traps bcaststorm
▫ Mode Global Config
8.5.27.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps are sent only if the broadcast storm
recovery mode setting associated with the port is enabled.
▫ Format no snmp-server enable traps bcaststorm
▫ Mode Global Config
8.5.28 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent only if the Link Trap flag
setting associated with the port is enabled (see 'snmp trap link-status' command).
▫ Default Enabled
▫ Format snmp-server enable traps linkmode
▫ Mode Global Config
8.5.28.1 no snmp-server enable traps linkmode