PLANET WGS3-2820 - Manual (Page 420)

User’s Manual of WGS3-2820/WGS3-5220
420
▫ Bridge Hold Time - Minimum time between transmission of Configuration Bridge Protocol Data Units (BPDUs)
11.1.2 show spanning-tree interface
This command displays the settings and parameters for a specific switch port within the common and internal spanning tree.
The <slot/port> is the desired switch port. The following details are displayed on execution of the command.
▫ Format show spanning-tree interface <slot/port>
▫ Mode Privileged EXEC and User EXEC
▫ Port mode - Enabled or disabled.
▫ Port Up - Time Since Counters Last Cleared Time since port was reset, displayed in days, hours, minutes, and
seconds.
▫ STP BPDUs - Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent
▫ STP BPDUs Received - Spanning Tree Protocol Bridge Protocol Data Units received.
▫ RST BPDUs Transmitted - Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
▫ RST BPDUs Received - Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
▫ MSTP BPDUs Transmitted - Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
▫ MSTP BPDUs Received - Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
11.1.3 show spanning-tree mst detailed
This command displays settings and parameters for the specified multiple spanning tree instance. The instance <mstid> is a
number that corresponds to the desired existing multiple spanning tree instance ID. The following details are displayed.
▫ Format show spanning-tree mst detailed <mstid>
▫ Mode Privileged EXEC and User EXEC
▫ MST Instance ID
▫ MST Bridge Priority
▫ Time Since Topology Change - in seconds
▫ Topology Change Count - Number of times the topology has changed for this multiple spanning tree instance.
▫ Topology Change in Progress - Value of the Topology Change parameter for the multiple spanning tree instance
▫ Designated Root - Identifier of the Regional Root for this multiple spanning tree instance.
▫ Root Path Cost - Path Cost to the Designated Root for this multiple spanning tree instance
▫ Root Port Identifier - Port to access the Designated Root for this multiple spanning tree instance
▫ Associated FIDs - List of forwarding database identifiers associated with this instance.
▫ Associated VLANs - List of VLAN IDs associated with this instance.
11.1.4 show spanning-tree mst port detailed
This command displays the detailed settings and parameters for a specific switch port within a particular multiple spanning tree
instance. The instance <mstid> is a number that corresponds to the desired existing multiple spanning tree instance. The
<slot/port> is the desired switch port.
▫ Format show spanning-tree mst port detailed <mstid> <slot/port>
▫ Mode Privileged EXEC and User EXEC
▫ MST Instance ID