1 ip – PLANET WGS3-2820 User Manual
Page 202
User’s Manual of WGS3-2820/WGS3-5220
202
4.6.1 IP
4.6.1.1 IP Configuration
Use this menu to configure routing parameters for the switch as opposed to an interface.
Figure 4-6-1
IP Configuation
Configurable Data
。
Routing Mode
- Select enable or disable from the pulldown menu. You must enable routing for the switch before
you can route through any of the interfaces. The default value is disable.
。
IP Forwarding Mode
- Select enable or disable from the pulldown menu. This enables or disables the forwarding
of IP frames. The default value is enable.
Non-Configurable Data
。
Default Time to Live
- The default value inserted into the Time-To-Live field of the IP header of datagrams
originated by the switch, if a TTL value is not supplied by the transport layer protocol.
。
Maximum Next Hops
- The maximum number of hops supported by the switch. This is a compile-time constant.