PLANET WGS3-2820 - Manual (Page 56)

User’s Manual of WGS3-2820/WGS3-5220
56
This allows logging to any serial device attached to the host.
Configurable Data
。 Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log messages. Enable or
Disable logging by selecting the corresponding line on the pulldown entry field.
。 Severity Filter - A log records messages equal to or above a configured severity threshold. Select the severity option
by selecting the corresponding line on the pulldown entry field. These severity levels have been enumerated below:
- Emergency (0) : system is unusable
- Alert (1) : action must be taken immediately
- Critical (2) : critical conditions
- Error (3) : error conditions
- Warning (4) : warning conditions
- Notice(5) : normal but significant conditions
- Informational(6) : informational messages
- Debug(7) : debug-level messages
Figure 4-2-21 Event Log
4.2.5.6 Hosts Configuration
Figure 4-2-22 Host Configuration
Configurable Data
。 Host - This is a list of the hosts that have been configured for syslog. Select a host for changing the configuration or
choose to add a new hosts from the drop down list.
。 IP Address - This is the ip address of the host configured for syslog.