PLANET WGS3-2820 - Manual (Page 62)

User’s Manual of WGS3-2820/WGS3-5220
62
¾ Learning
¾ Forwarding
¾ Broken
。 Port Role - Each MST Bridge Port that is enabled is assigned a Port Role for each spanning tree. The port role will
be one of the following values: Root Port, Designated Port, Alternate Port, Backup Port, Master Port or Disabled
Port.
。 Admin Mode - The Port control administration state. The port must be enabled in order for it to be allowed into the
network. The factory default is enabled.
。 LACP Mode - Indicates the Link Aggregation Control Protocol administration state. The mode must be enabled in
order for the port to participate in Link Aggregation.
。 Physical Mode - Indicates the port speed and duplex mode. In auto-negotiation mode the duplex mode and speed
are set from the auto-negotiation process.
。 Physical Status - Indicates the port speed and duplex mode.
。 Link Status - Indicates whether the Link is up or down.
。 Link Trap - Indicates whether or not the port will send a trap when link status changes.
。 ifIndex - Indicates the ifIndex of the interface table entry associated with this port.
4.2.6.3 Multiple Port Mirroring
Use this page to configure the multiple port mirroring.
Figure 4-2-29 Multiple Port Mirroring
Configurable Data
。 Session ID - A session ID or "All Sessions" option may be selected. By default the First Session is selected.
。 Session Mode - Specifies the Session Mode for a selected session ID. By default Session Mode is enabled.
。 Source Port(s) - Specifies the configured port(s) as mirrored port(s). Traffic of the configured port(s) is sent to the
probe port.
。 Destination Port - Acts as a probe port and will recieve all the traffic from configured mirrored port(s). Default value
is blank.