PLANET WGS3-2820 User Manual
Page 263
User’s Manual of WGS3-2820/WGS3-5220
263
。
VRID and Slot/Port
- Select 'Create' from the pulldown menu to configure a new Virtual Router, or select one of the
existing Virtual Routers, listed by interface number and VRID.
Configurable Data
。
VRID
- This field is only configurable if you are creating new Virtual Router, in which case enter the VRID in the
range 1 to 255 .
。
Slot/Port
- This field is only configurable if you are creating new Virtual Router, in which case select the Slot/Port for
the new Virtual Router from the pulldown menu.
。
Pre-empt Mode
- Select enable or disable from the pulldown menu. If you select enable a backup router will
preempt the master router if it has a priority greater than the master virtual router's priority provided the master is
not the owner of the virtual router IP address. The default is enable.
。
Priority
- Enter the priority value to be used by the VRRP router in the election for the master virtual router. If the
Virtual IP Address is the same as the interface IP Address, the priority gets set to 255 no matter what the user
enters. If the user enters a priority of 255 when the Virtual and interface IP Addresses are not the same, the priority
gets set to the default value of 100.
。
Advertisement Interval
- Enter the time, in seconds, between the transmission of advertisement packets by this
virtual router. Enter a number between 1 and 255. The default value is 1 second.
。
IP Address
- Enter the IP Address associated with the Virtual Router. The default is 0.0.0.0.
。
Authentication Type
- Select the type of Authentication for the Virtual Router from the pulldown menu. The default
is None. The choices are:
0-None
- No authentication will be performed.
1-Simple
- Authentication will be performed using a text password.
。
Authentication Data
- If you selected simple authentication, enter the password.
。
Status
- Select active or inactive from the pulldown menu to start or stop the operation of the Virtual Router. The
default is inactive.
Non-Configurable Data
。
Interface IP Address
- Indicates the IP Address associated with the selected interface.
Command Buttons
。
Submit
- Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
。
Delete
- Delete the selected Virtual Router. Note that the router can not be deleted if there are secondary
addresses configured.
。
Secondary IP Address
- Proceed to the Secondary IP Address configuration screen.