PLANET WGS3-2820 - Manual (Page 28)

User’s Manual of WGS3-2820/WGS3-5220
28
2.2.2 Rack Mounting
To install the WGS3 LAYER 3 Switch in a 19-inch standard rack, please follows the instructions described below.
Step1: Place the WGS3 LAYER 3 Switch on a hard flat surface, with the front panel positioned towards the front side.
Step2: Attach the rack-mount bracket to each side of the WGS3 LAYER 3 Switch with supplied screws attached to the package.
Figure 2-4 shows how to attach brackets to one side of the WGS3 LAYER 3 Switch.
Figure 2-4 Attach brackets to the WGS3 LAYER 3 Switch.
Caution:
You must use the screws supplied with the mounting brackets. Damage caused to the parts by using incorrect screws
would invalidate the warranty.
Step3: Secure the brackets tightly.
Step4: Follow the same steps to attach the second bracket to the opposite side.
Step5: After the brackets are attached to the WGS3 LAYER 3 Switch, use suitable screws to securely attach the brackets to the
rack, as shown in Figure 2-5.
Figure 2-5 Mounting the WGS3 LAYER 3 Switch in a Rack
Step6: Proceeds with the steps 4 and steps 5 of session 2.2.1 Desktop Installation to connect the network cabling and supply
power to the WGS3 LAYER 3 Switch.