PLANET WGS3-2820 User Manual
Page 257
User’s Manual of WGS3-2820/WGS3-5220
257
。
Submit
- Send the updated configuration to the switch. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
4.6.7.2 BOOTP/DHCP Relay Agent Status
Figure 4-6-40
BOOTP/DHCP Relay Agent Status
Non-Configurable Data
。
Maximum Hop Count
- The maximum number of Hops a client request can go without being discarded.
。
Server IP Address
- IP address of the BOOTP/DHCP server or the IP address of the next BOOTP/DHCP Relay
Agent.
。
Admin Mode
- Administrative mode of the relay. When you select 'enable' BOOTP/DHCP requests will be
forwarded to the IP address you entered in the 'Server IP address' field.
。
Minimum Wait Time
- The Minimum time in seconds. This value will be compared to the time stamp in the client's
request packets, which should represent the time since the client was powered up. Packets will only be forwarded
when the time stamp exceeds the minimum wait time.
。
Circuit Id Option Mode
- This is the Relay agent option which can be either enabled or disabled. When enabled
Relay Agent options will be added to requests before they are forwarded to the server and removed from replies
before they are forwarded to clients.
。
Requests Received
- The total number of BOOTP/DHCP requests received from all clients since the last time the
switch was reset.
。
Requests Relayed
- The total number of BOOTP/DHCP requests forwarded to the server since the last time the
switch was reset.
。
Packets Discarded
- The total number of BOOTP/DHCP packets discarded by this Relay Agent since the last time
the switch was reset.