PLANET WGS3-2820 - Manual (Page 503)

User’s Manual of WGS3-2820/WGS3-5220
503
range for <count> is 1 to 20.
▫ Default 2
▫ Format ip igmp startup-query-count <count>
▫ Mode nterface Config
no ip igmp startup-query-count (only for Layer 3 Series)
This command resets the number of Queries sent out on startup, separated by the Startup Query Interval on the interface to the
default value.
▫ Format no ip igmp startup-query-count
▫ Mode Interface Config
13.3.10 ip igmp startup-query-interval
This command sets the interval between General Queries sent by a Querier on startup on the interface. The time interval value
is in seconds. The range for <interval> is 1 to 300 seconds.
▫ Default 31
▫ Format ip igmp startup-query-interval <interval>
▫ Mode Interface Config
no ip igmp startup-query-interval
This command resets the interval between General Queries sent by a Querier on startup on the interface to the default value.
▫ Format no ip igmp startup-query-interval
▫ Mode Interface Config
13.3.11 set igmp groupmembershipinterval
This command sets the IGMP Group Membership Interval time on a particular interface or VLAN. The Group Membership
Interval time is the amount of time in seconds that a switch will wait for a report from a particular group on a particular interface
before deleting the interface from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The
range is 2 to 3600 seconds.
▫ Default 260 seconds
▫ Format set igmp groupmembershipinterval <vlanId> <2-3600>
▫ Mode Interface Config Vlan Mode
no set igmp groupmembershipinterval
This command sets the IGMPv3 Group Membership Interval time (on the interface or the VLAN) to the default value.
▫ Format no set igmp groupmembershipinterval
▫ Mode Interface ConfigVlan Mode