PLANET WGS3-2820 User Manual
Page 304
User’s Manual of WGS3-2820/WGS3-5220
304
Configurable Data
o
PIMSM Admin Mode
- Select enable or disable from the pulldown menu to set the administrative status of PIM-SM
in the router. You must enable IGMP before enabling PIM-SM. The default is disable.
o
Join/Prune Interval
- Enter the interval between the transmission of PIM-SM Join/Prune messages. The valid
values are from (10 to 3600 secs). The default value is 60.
o
Data Threshold Rate
- Enter the minimum source data rate in K bits/second above which the last-hop router will
switch to a source-specific shortest path tree. The valid values are from (0 to 2000 K bits/sec) . The default value is
50.
o
Register Threshold Rate
- Enter the minimum source data rate in K bits/second above which the Rendezvous
Point router will switch to a source-specific shortest path tree. The valid values are from (0 to 2000 K bits/sec) . The
default value is 50.
Command Buttons
o
Submit
- Send the updated configuration to the router. Configuration changes take effect immediately. These
changes will not be retained across a power cycle unless a save is performed.
#
Note
:
Only one multicast routing protocol could be enabled at one time. That means, for example, once
the PIM-DM admin mode is enabled, the user is not able to enable the DVMRP.
4.7.6.2 PIM-SM Global Parameters
Figure 4-6-79
PIM-SM Global Parameters
Non-Configurable Data