PLANET WGS3-2820 - Manual (Page 169)

User’s Manual of WGS3-2820/WGS3-5220
169
4.4.3.2 Server Configuration
This page is to configure the TACACS+ Serve, include IP Address, port and and Key String.
Figure 4-4-18 TACACS+ Server Configuration
Selection Criteria
。 TACACS+ Server Selects the TACACS+ server for which data is to be displayed or configured. If the add item is
selected, a new TACACS server can be configured.
Configurable Data
。 IP Address - Specifies the TACACS+ Server IP address.
。 Priority - Specifies the order in which the TACACS+ servers are used. It should be within the range 0-65535.
。 Port - Specifies the authentication port. It should be within the range 0-65535.
。 Key String - Specifies the authentication and encryption key for TACACS+ communications between the device and
the TACACS+ server. The valid range is 0-128 characters. The key must match the encryption used on the
TACACS+ server.
。 Connection Timeout - The amount of time that passes before the connection between the device and the TACACS+
server time out. The range is between 1-30.
Command Buttons
。 Submit - Send the updated screen to the switch and cause the changes to take effect on the switch but these
changes will not be retained across a power cycle unless a save is performed.
。 Remove - Remove the selected server from the configuration.