PLANET WGS3-2820 - Manual (Page 504)

User’s Manual of WGS3-2820/WGS3-5220
504
13.3.12 set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, on a particular interface or VLAN. The Maximum
Response time is the amount of time in seconds that a switch will wait after sending a query on an interface because it did not
receive a report for a particular group in that interface. This value must be less than the IGMP Query Interval time value. The
range is 1 to 3599 seconds.
▫ Default 10 seconds
▫ Format set igmp maxresponse <1-3599>
▫ Mode Global Config Interface Config Vlan Mode
no set igmp maxresponse
This command sets the IGMP Maximum Response time (on the interface or VLAN) to the default value.
▫ Format no set igmp maxresponse
▫ Mode Global ConfigInterface Config Vlan Mode
13.3.13 set igmp mrouter interface
This command configures a selected interface as a multicast router interface. When configured as a multicast router interface,
the interface is treated as a multicast router interface in all VLANs. Default disable
▫ Format set igmp mrouter interface
▫ Mode Interface Config
no set igmp mrouter interface
This command disables the status of the interface as a statically configured multicast router interface.
▫ Format no set igmp mrouter interface
▫ Mode Interface Config
.
13.3.14 set igmp mrouter
This command configures the VLAN ID(<vlanId>) that has the multicast router mode enabled.
▫ Format set igmp mrouter <vlanId>
▫ Mode Interface Config
no set igmp mrouter
This command disables multicast router mode for a particular VLAN ID (<vlanId>).
▫ Format no set igmp mrouter <vlanId>
▫ Mode Interface Config