PLANET WGS3-2820 - Manual (Page 118)

User’s Manual of WGS3-2820/WGS3-5220
118
4.3.5.2 IGMP Snooping Interface Configuration
Figure 4-3-20 IGMP Snooping Interface Configuration
Configurable Data
。 Slot/Port - The single select box lists all physical ,VLAN and LAG interfaces. Select the interface you want to
configure.
。 Admin Mode - Select the interface mode for the selected interface for IGMP Snooping for the switch from the
pulldown menu.
The default is disable.
。 Group Membership Interval - Specify the amount of time you want the switch to wait for a report for a particular
group on a particular interface before it deletes that interface from the group. Enter a value between 1 and 3600
seconds.
The default is 260 seconds.
。 Max Response Time - Specify the amount of time you want the switch to wait after sending a query on an interface
because it did not receive a report for a particular group on that interface. Enter a value greater or equal to 1 and
less than the Group Membership Interval in seconds.
The default is 10 seconds. The configured value must be less than the Group Membership Interval.
。 Multicast Router Present Expiration Time - Specify the amount of time you want the switch to wait to receive a
query on an interface before removing it from the list of interfaces with multicast routers attached. Enter a value
between 0 and 3600 seconds.
The default is 0 seconds. A value of zero indicates an infinite timeout, i.e. no expiration.
。 Fast Leave Admin mode - Select the Fast Leave mode for the a particular interface from the pulldown menu.
The default is disable.
Command Buttons
。 Submit - Update the switch with the values you entered. If you want the switch to retain the new values across a
power cycle you must perform a save. You will only see this button if you have Read/Write access privileges.