PLANET WGS3-2820 - Manual (Page 112)

User’s Manual of WGS3-2820/WGS3-5220
112
4.3.4 GARP
4.3.4.1 GARP Status
This screen shows the GARP Status for the switch and for the individual ports. Note that the timers are only relevant when the
status for a port shows as enabled.
Figure 4-3-16 GARP Status
。 Switch GVRP - Indicates whether the GARP VLAN Registration Protocol administrative mode for this switch is
enabled or disabled. The factory default is disabled.
。 Switch GMRP - Indicates whether the GARP Multicast Registration Protocol administrative mode for this switch,
enabled or disabled. The factory default is disabled.
。 Slot.Port - Slot.Port of the interface.
。 Port GVRP Mode - Indicates whether the GVRP administrative mode for the port is enabled or disabled. The
factory default is disabled.
。 Port GMRP Mode - Indicates whether the GMRP administrative mode for the port is enabled or disabled. The
factory default is disabled.
。 Join Time (centiseconds) - Specifies the time between the transmission of GARP PDUs registering (or
re-registering) membership for a VLAN or multicast group in centiseconds. An instance of this timer exists for each
GARP participant for each port. Permissible values are 10 to 100 centiseconds (0.1 to 1.0 seconds). The factory
default is 20 centiseconds (0.2 seconds).
。 Leave Time (centiseconds) - Specifies the time to wait after receiving an unregister request for a VLAN or
multicast group before deleting the associated entry, in centiseconds. This allows time for another station to assert
registration for the same attribute in order to maintain uninterrupted service. An instance of this timer exists for
each GARP participant for each port. Permissible values are 20 to 600 centiseconds (0.2 to 6.0 seconds). The
factory default is 60 centiseconds (0.6 seconds).