PLANET WGS3-2820 - Manual (Page 343)

User’s Manual of WGS3-2820/WGS3-5220
343
8.5.22 snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the associated community SNMP packet sending
address and is used along with the client IP address value to denote a range of IP addresses from which SNMP clients may use
that community to access the device. A value of 255.255.255.255 will allow access from only one station, and will use that
machine's IP address for the client IP Address. A value of 0.0.0.0 will allow access from any IP address. The name is the
applicable community name.
▫ Default 0.0.0.0
▫ Format snmp-server community ipmask <ipmask> <name>
▫ Mode Global Config
8.5.22.1 no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is the applicable community name. The
community name may be up to 16 alphanumeric characters.
▫ Format no snmp-server community ipmask <name>
▫ Mode Global Config
8.5.23 snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP manager associated with this community
manages the switch according to its access right. If the community is disabled, no SNMP requests using this community are
accepted. In this case the SNMP manager associated with this community cannot manage the switch until the Status is
changed back to Enable.
▫ Default The default private and public communities are enabled by default. The four undefined communities are
disabled by default.
▫ Format snmp-server community mode <name>
▫ Mode Global Config
8.5.23.1 no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no SNMP requests using this community are
accepted. In this case the SNMP manager associated with this community cannot manage the switch until the Status is
changed back to Enable.
▫ Format no snmp-server community mode <name>
▫ Mode Global Config
8.5.24 snmp-server community ro
This command restricts access to switch information. The access mode is read-only (also called public).
▫ Format snmp-server community ro <name>
▫ Mode Global Config