PLANET WGS3-2820 - Manual (Page 433)

User’s Manual of WGS3-2820/WGS3-5220
433
12.1.19 show arp switch
This command displays the contents of the switch’s Address Resolution Protocol (ARP) table.
▫ Format show arp switch
▫ Mode Privileged EXEC
IP Address Is the IP address of a device on a subnet attached to the switch.
MAC Address Is the hardware MAC address of that device.
Interface Is the routing slot/port associated with the device’s ARP entry.
12.2 IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the switch.
12.2.1 routing
This command enables IPv4 and IPv6 routing for an interface. You can view the current value for this function with the show ip
brief command. The value is labeled as “Routing Mode.”
▫ Default disabled
▫ Format routing
▫ Mode Interface Config
12.2.2 no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The value is labeled as “Routing Mode.”
▫ Format no routing
▫ Mode Interface Config
12.2.3 ip routing
This command enables the IP Router Admin Mode for the master switch.
▫ Format ip routing
▫ Mode Global Config