PLANET WGS3-2820 - Manual (Page 298)

User’s Manual of WGS3-2820/WGS3-5220
298
4.7.4.7 Mtrace Show
This screen displays the results of an mtrace command. The mtrace command is used to trace the path from source to a
destination branch for a multicast distribution tree.
Figure 4-6-74 Mtrace Show
Non-Configurable Data
o Number of hops away from destination - The number of hops away from the destination.
o IP address of intermediate router - The IP address of the intermediate router in the path being traced between
source and destination for the hop number in the previous field.
o Multicast Protocol in use - The multicast protocol in use on this hop.
o TTL Threshold - The time-to-live threshold on this hop.
o Time taken to forward between hops - The time taken for the trace request to be forwarded from the previous hop
to this hop.
Command Buttons
o New Mtrace - Redirect the web browser to the Mtrace Run screen so that you can initiate another mtrace command.
o Refresh - Refresh the content of the screen with the latest data available on the router. Typically, it takes around 20
seconds to process the results after initiating mtrace command. You must refresh the screen to display the latest
results.