PLANET WGS3-2820 - Manual (Page 438)

User’s Manual of WGS3-2820/WGS3-5220
438
12.2.19 encapsulation
This command configures the link layer encapsulation type for the packet. The encapsulation type can be ethernet or snap.
▫ Default ethernet
▫ Format encapsulation {ethernet | snap}
▫ Mode Interface Config
"
Note : Routed frames are always ethernet encapsulated when a frame is routed to a VLAN.
12.2.20 show ip brief
This command displays all the summary information of the IP.
▫ Format show ip brief
▫ Modes Privileged EXEC
User EXEC
▫ Default Time to Live
The computed TTL (Time to Live) of forwarding a packet from the local router to the final destination.
Routing Mode Shows whether the routing mode is enabled or disabled.
IP Forwarding Mode Shows whether forwarding of IP frames is enabled or disabled. This is a configured value.
Maximum Next Hops Shows the maximum number of next hops the packet can travel.
12.2.21 show ip interface
This command displays all pertinent information about the IP interface.
Format show ip interface <slot/port>
Modes Privileged EXEC
User EXEC
Primary IP Address Displays the primary IP address and subnet masks for the interface.
This value appears only if you configure it.
Secondary IP Address Displays one or more secondary IP addresses and subnet masks for the interface.
This value appears only if you configure it.
Routing Mode Is the administrative mode of router interface participation.
The possible values are enable or disable. This value was configured into the unit.
Administrative Mode Is the administrative mode of the specified interface. The possible values of this field are