PLANET WGS3-2820 User Manual
Page 140
User’s Manual of WGS3-2820/WGS3-5220
140
。
Admin Edge Port
- Specifies if the specified port is an Edge Port within the CIST. It takes a value of TRUE or
FALSE, where the default value is FALSE.
。
Port Path Cost
- Set the Path Cost to a new value for the specified port in the common and internal spanning tree.
It takes a value in the range of
1 to 200000000
.
。
Hello Timer
- Configure the value of the parameter for the CST.
。
External Port Path Cost
- Set the External Path Cost to a new value for the specified port in the spanning tree. It
takes a value in the range of
1 to 200000000
.
。
Port Mode
- Spanning Tree Protocol Administrative Mode associated with the port or port channel. The possible
values are Enable or Disable.
Non-Configurable Data
Figure 4-3-37
Spanning Tree CST Port Configuration/Status
。
Auto-calculate Port Path Cost
- Displays whether the path cost is automatically calculated (Enabled) or not
(Disabled). Path cost will be calculated based on the link speed of the port if the configured value for Port Path Cost
is zero.
。
Auto-calculate External Port Path Cost
- Displays whether the external path cost is automatically calculated
(Enabled) or not (Disabled). External Path cost will be calculated based on the link speed of the port if the
configured value for External Port Path Cost is zero.
。
Port ID
- The port identifier for the specified port within the CST. It is made up from the port priority and the interface
number of the port.
。
Port Up Time Since Counters Last Cleared
- Time since the counters were last cleared, displayed in Days, Hours,
Minutes, and Seconds.
。
Port Forwarding State
- The Forwarding State of this port.