Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 137)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
5-39
Define Thresholds for an Analogue Input Module
To define your own threshold values do the following:
1) Select the Thresholds tab on the module editor.

A set of default values is shown in the threshold fields.
2) To enter your own values select the Use Custom Thresholds box, enter your
own values in the threshold fields, click Apply.
Note: You can enter the values in counts (the default units) or in milliamps. To
specify a value in milliamps, append 'mA' to the value; the AADvance Workbench
will convert it into counts.
3) To restore the default values, Click Default then de-select the Use Custom
Thresholds box, click Apply.