Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 236)

 

10-2 Document: 553633
ICSTT-RM405f-EN-P
Issue 07
Configuration Guide (AADvance Controller)
SNCP Networks
You can set up a single SNCP network to communicate with the target. When two
controllers are set up with their IP Addresses on the same subnet, they also appear on
the same physical network. This single logical network can also be used to configure
variable bindings over redundant physical networks.
Setting Up Single Networks
When you create a project it has a default single network configuration.
1) Create a project.

This configuration represents a single logical network.

The configured IP address is the IP address used by the Workbench to
communicate with the target.