Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 41)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
4-1
This chapter describes the process to configure the processor modules:
In This Chapter
View Module Firmware Versions .................................................................... 4-1
ControlFLASH Firmware Upgrades ............................................................... 4-5
Configure Controller Type (Standard or Eurocard) ................................ 4-19
Configure the Top-level Process Safety Time (PST) ................................ 4-20
Configure the Processor Battery Alarm ..................................................... 4-21
Configure the Serial Ports .............................................................................. 4-22
Time Synchronization (SNTP) ....................................................................... 4-24
Using the Controller as a Modbus Slave ..................................................... 4-27
Transparent Communication Interface (TCI) ............................................ 4-30
DiffServ Configuration ..................................................................................... 4-32
Ethernet Forwarding ........................................................................................ 4-34
About T9110 Processor Variables................................................................ 4-36
Set the Processor clock .................................................................................. 4-54
View Module Firmware Versions
Using the AADvance Workbench you can view the module firmware information on
screen and save this information with your project. Using an update function view the
latest information and save it as an external text file.
To do this proceed as follows:
Note: To view the firmware version numbers of the modules you must be connected
using Debug to a running controller.
1) Select the Equipment View tab.
2) Select the desired configuration node Config4(9000 Series Controller) in
example shown below.
3) Select the Version Information tab.

The version information window appears. If the version information has
previously been requested and saved (applied) then it will be visible in this
window.
Chapter 4
Configuring the Processor Modules