Rockwell Automation AADvance Controller Configuration Guide - Manual (Page 155)

 
Document: 553633
ICSTT-RM405f-EN-P
Issue 07
6-1
This chapter provides an overview of the setting up process for the AADvance
AADvance Workbench, including creating a new project.
In This Chapter
Create a New Project ....................................................................................... 6-1
Compiler Verification Tool .............................................................................. 6-2
Allocate IP Addresses for Network Communications .............................. 6-4
Configure the IP Address of the Target Controller................................... 6-5
Create a New Project
The configuration process starts by creating a new AADvance project. To create a
new project do the following:
1) Start the AADvance AADvance Workbench.
2) Select File then New Project/Library (<ctrl>+N).

The New dialog box opens.
3) Enter a project name (maximum of 128 characters) and add a comment line.
4) Choose the AADvance_System template from the drop down list, click OK.

The AADvance Workbench creates a project.
Chapter 6
Setting Up